Teachers.Net
JoinLog in
Teachers.Net

Clever Levers

By Kjackson

  • Science
  • Middle
Activity Time
1 Class Period
Materials
1 meter stick, 3 large paper clips, paper cup, masking tape, pencil, 2 rulers, rubber band, masses
Concepts / Topics
Levers help to lift loads with less effort.

Learners build a meter-stick lever, measure rubber band stretch as they move a cup load, graph total and net stretch, and discuss what the data show.

Key Question

When using a lever with the least amount of effort, where should the load and the effort be placed?

Procedure

  1. Discuss key vocabulary and the Law of Conservation of Energy.
  2. Distribute the materials along with the chart.
  3. Build the lever using the following instructions:

    1. Open a paper clip into an “S” and tape it perpendicular to a meter stick at the 10 cm mark. Tape it so that the larger end of the S sticks out above the top of the meter stick.
    2. Tape a pencil to the top of the table so that the end with the eraser sticks out 2 cm.
    3. Hang the meter stick by the end of the paper clip on the end of the pencil. This is the fulcrum of the lever.
    4. Slip the rubber band into one of the hooks of another paper clip. Slide the rubber band onto the end of the meter stick opposite the pencil until it is at the 90 cm mark. Tape the paper clip to the top of a table so it supports the meter stick by the rubber band. Make sure the rubber band is still at the 90 cm mark before you tape it down. This is where the effort on the lever will be measured.
    5. Bend a third paper clip into an “S.” Poke the smaller hook into a paper cup just below the rim. Add weight to the cup as instructed by the teacher. By hanging the big hook on the meter stick, you will be putting the resistance on the lever.
  4. Measure the length of the rubber band before adding resistance. Measure to the nearest mm and record the length on the chart beside “Total Stretch” and under “Lever with No Resistance.”
  5. Hang the cup with its mass at the fulcrum. Measure and record the total stretch of the rubber band and calculate the net stretch (total stretch minus stretch with no resistance). Although you will read these measurements in mm, they will be recorded in rubber band units.
  6. Move the resistance 200 mm. Measure and record the total stretch, and calculate the net stretch.
  7. Make a line graph using values for the total stretch from your data.
  8. Graph the net stretch as a second line on the graph. Label both lines.
  9. Discuss the results from the graph and make conclusions based on the results. Also, answer the key question based on the data gained.

Teachers.Net · https://teachers.net/lessons/194.html