Making A Wet Cell Battery
- Science
- Middle

- Activity Time
- Materials
- Concepts / Topics
- Resource Type
Learners assemble a copper and zinc wet cell, measure its voltage, then add mild acids and observe voltage changes.
Procedure
- Pour about 200 mL of tap water into a 250 mL beaker. Using one of the alligator clips, clip the copper strip to the rim of the beaker so that at least part of the strip is below the surface of the water. On the opposite side of the beaker, do the same with the zinc strip and the other alligator-clip wire. You can move the copper and zinc strips around, but don't let them touch.
- Check your setup: the copper and zinc strips should be clipped to opposite sides of the same beaker of water. You should have two free alligator clips, one connected to the zinc and the other to the copper. Connect these two clips to the two leads from the multitester, and, presto, you should observe about one volt of electricity!
- Experiment by adding a drop or two of lemon juice to the mixture. Does the voltage change? Try other drops of mild acids, such as orange juice or vinegar.
What Is Happening Here?
The copper is acting as a positive terminal. The zinc is the negative terminal. Free electrons are breaking away from the zinc and migrating across the water, forming ions. The ions are being accepted by the copper, and a battery is born!
Using a Digital Multitester
This experiment works well if you have a digital multitester. You can watch the acids you drop in cause the multitester to indicate a spike in the voltage. Have fun!
Teachers.Net · https://teachers.net/lessons/317.html