Tree Bagging
- Science
- Senior

- Activity Time
- Materials
- Concepts / Topics
Students bag tree parts, collect and measure water and dried biomass, calculate a water-to-biomass ratio, analyze transpiration estimates and factors, and write a conclusion.
Environmental Science Investigation
Tree Bagging to Explore Evapotranspiration and the Water Cycle
The most poorly understood part of the water cycle is the process of evapotranspiration, by which plants give off water from their leaves to the atmosphere. The process of transpiration was greatly ignored in most introductory science courses and only lately is entering science curricula as rain forests, a major source of atmospheric water, continue to disappear at an alarming rate.
In this investigation, tree parts will be bagged and a water transpiration to biomass ratio will be calculated from the collected data.
Objectives
- Bag trees (the technique will be demonstrated in class).
- Determine the mass of water given off.
- Determine the mass of the tree part.
- Calculate the water mass to tree mass ratio: divide grams of water by grams of tree and label the result water mass/tree mass.
Procedure
Make a “Data/Calculations” section on your paper and show all data recorded. In that section, make a chart or table as shown below for your data. Use units on all numbers and show your calculations.
| Measurement or calculation | Mass (grams) |
|---|---|
| 1. Tree + Bag + Water + Tape | __________ |
| 2. Dried Bag + Tape | __________ |
| 3. Dried Tree | __________ |
| 4. Water = #1 − (#2 + #3) | __________ |
- Bag the trees after the class demonstration. Make sure the tape is a snug fit and touches both the tree and bag all the way around. Allow the trees two or more days to photosynthesize if possible. Read the steps below and set up an appropriate data table.
- Carefully collect the bagged tree parts so as not to lose any water. Keep the opening upward.
- Measure the mass of the bag, tree parts, and water together.
- Separate the tree parts from the bag and tape. The water may be poured out now.
- Measure the mass of the dried bag and tape after waving them in the air to dry.
- Measure the mass of the tree parts after waving them in the air to dry. Pick up any leaves or needles that fall and include them.
- By subtraction, determine the mass of water.
- Determine the ratio by dividing the water mass by the mass of the dried tree parts (#4 / #3).
Analysis
- If the area you bagged had a volume of 1 ft³, how much water would you expect to see transpired for a tree with a volume of 1,000 ft³?
- If there are 40,000 trees of the size in question 1 in an area, how much water would they give off in the length of time that you had your trees bagged?
- In six months, how much water would the 40,000 trees put into the atmosphere?
How and why would the following factors probably affect transpiration?
- Temperature
- Length of day
- Time of year
- Drought
- Look at your water to biomass ratio. Notice that it shows how much water is transpired for each unit of tree biomass. How long would it take the tree to put water equivalent to its entire mass into the atmosphere?
Conclusion
Write a short paragraph commenting on what you learned from this activity.
Teachers.Net · https://teachers.net/lessons/59.html